EAGLE Library Files for BusCard Project

These are the custom EAGLE library files I have prepared for various components of the reverse-engineered BusCard EAGLE PCB model.

EAGLE Library Files for BusCard Components

• TMS 2564 (65,536-Bit, Ultraviolet-light-erasable, EPROM) (13 KB .lbr file)
• Commodore card edges (Commodore IEEE-488 card-edge, parallel port card-edge, C64 expansion port card-edge) (70 KB .lbr file)
• Female socket for 44-pin Commodore 64 expansion port card edge (33 KB .lbr file)
• 8-bit Programmable Peripheral Interface (14 KB .lbr file)
• 75160 IEEE-488 GPIB Transceiver (10 KB .lbr file)
• 75161 IEEE-488 GPIB Transceiver (10 KB .lbr file)
• 1N4148 Small Signal Diode (15 KB .lbr file)
• 2N3904 and 2N4401 NPN Transistors (8 KB .lbr file)
• 74LS00N Quadruple 2-Input Positive-NAND Gates (17 KB .lbr file)
• 74LS04N Hex Inverting Gates (17 KB .lbr file)
• 74LS08N Quadruple 2-Input Positive-AND Gates (17 KB .lbr file)
• 74LS21N Dual 4-Input Positive-AND Gates (17 KB .lbr file)
• 74LS32N Quadruple 2-Input Positive-OR Gates (18 KB .lbr file)
• 74LS139N Dual 1-of-4 Decoder/Demultiplexer (18 KB .lbr file)
• CK05BX104K Ceramic Capacitor, 0.1 uF (7 KB .lbr file)
• Wire-to-board connector header, 2-position, 1-row, 90-degrees, 0.1" (2.54 mm) contact spacing (pitch), MTA-100 Series, for BusCard Clip (7 KB .lbr file)
• 8 SPST, DIP Switch, Raised Slide (14 KB .lbr file)
• Frame for Circuit Diagram Drawing, 28 x 20 inches (7 KB .lbr file)
• Wire-to-board connector header, 3-position, 1-row, straight, 0.1" (2.54 mm) contact spacing (pitch), MTA-100 Series, for BusCard Jumpers (8 KB .lbr file)
• Wire-to-board connector header, 4-position, 1-row, straight, 0.1" (2.54 mm) contact spacing (pitch), MTA-100 series, for Diagnostic Plug (9 KB .lbr file)
• Resistor (15 KB .lbr file)
• 4.67 kohm Resistor Network (17 KB .lbr file)

P. David Buchan pdbuchan@gmail.com